Category
Putties and FillersHigh-quality, white cement-based powder designed to create smooth, even wall surfaces by covering imperfections, unevenness, and pinholes before the final finish. Suitable for both interior and exterior applications, it offers excellent workability, easy application, and good adhesion to cement plaster surfaces. Compatible with plasterwork, brick, block, concrete, and timber, it helps achieve a smoother, brighter finish that enhances the overall appearance of your walls. Its non-flammable formulation makes it a reliable choice for quality wall preparation.
The product can be applied by: Stainless Steel trowel or spatula
Spreading Capacity per coat: Depends on film thickness applied, type of texture, surface porosity,
imperfections, temperature & wastage during painting.
15 – 20m2 per 25kg bag @1 – 1.5mm thickness for 2 coats.
Surface preparation: Brush out any loose dust, chalk, grease, fungi, algae and old paint flakes.
Surfaces with more than 2mm undulations need to be re-plastered. Fill up all major cracks and
defects with cement and sand mixture.
Mixing: Mix 2 parts powder and 1-part water by volume. Add the powder to the water with
mixing until the desired consistency is achieved. Leave to mature for 10 minutes. Remix again
for 2 minutes. Product has a short pot-life of 1 hour at 25oC. Mix only enough quantity to be
used within the pot-life.
Application:
• Thoroughly pre-wet the surface to provide better bonding strength, coverage and ease of
application. Allow excess water to drip off.
• Apply the first coat of the above mixture to a thickness of 0.5 to 1mm from bottom to upward
direction uniformly with the help of a Stainless Steel or plastic Trowel or spatula to reduce
wastage.
• Level and smoothen the surface and allow to dry for 4-12 hours.
• After drying of first coat rub the surface very gently with the putty blade to remove loose
particles.
• Apply the 2nd coat 0.5 – 1mm thickness horizontally to even out application marks from the
1st coat and smoothen with a trowel.
• The thickness of each coat must not exceed 1mm and total plaster thickness should not
exceed 2mm.
• Leave to dry overnight. Sand smooth with P320 or finer sandpaper
Drying Times: Surface dry: 1 hour. Setting time: 2 hours. Dry to sand: 4 - 12 hours.
Tanzania
Uganda
Rwanda
